ELTEX NTU-RG-5402G-W - RIP Submenu. RIP Configuration; Samba Submenu. Configuration of Samba Users

 NTU-RG-54xx Operational manual
32
4.3.5 "RIP" submenu. RIP configuration
Enable RIP if you use this device as a RIP enabled device to communicate with other users via RIP. This page
is used to select interfaces that utilize RIP and the version of protocol being used.
Services → RIP
To use RIP, set the "Enable" flag.
Click the "Apply/Save" to accept and save the settings.
• Interface– interface on which RIP will be started;
• Receive Mode–incoming packets processing mode (NONE, RIP1, RIP2, both);
• Send Mode (NONE, RIP1, RIP2, RIP1 compat).
4.3.6 "Samba" submenu. Configuration of Samba users
In this submenu you can configure Samba; to enable the setting, set the "Enable" flag.
Services → Samba