ELTEX NTU-RG-5402G-W - Wireless Menu. Wireless Network Configuration; Basic Settings Submenu. Basic Settings

 NTU-RG-54xx Operational manual
22
4.2 "Wireless" menu. Wireless network configuration
This section contains individual settings for each of the operating bands – 2.4 GHz and 5 GHz.
4.2.1 "Basic settings" submenu. Basic settings
This menu is intended for general setup of the LAN wireless interface and allows user to specify up to three
wireless access points.
Wireless → wlan0 (2.4GHz) / wlan1 (5GHz)  → Basic settings
• Disable WLAN Interface –disable radio interface;
• Band –change Wi-Fi operation standard;
• Mode –switch the "access point/client" operation mode;
• SSID (Service Set Identifier)–assign a wireless network name (case sensitive).
Default device SSID is ELTX-2.4GHz_WiFi__aaaa/ELTX-5GHz_WiFi_aaaa, where аааа – the last 4 digits of
WAN MAC. WAN MAC is labelled on the device housing. The network name contains a frequency band
(2.4/5GHz).
• Channel Width –20/40 MHz bandwidth;
• Control Sideband–select the second channel (Lower or Upper) in 40 MHz mode;
• Channel Number –utilized channel;
• Radio Power –transmitter power;
• Limit Associated Client Number–limit the maximum amount of associated clients;
• Associated Clients –maximum amount of associated clients;
• Enable Universal Repeater Mode (Acting as AP and client simultaneously);
• Regdomain – regulatory domain.
Click the Apply Changes to accept the changes.