electrostatic
innovations
8 BA-en-1022-0802_PGT120
2. Safety
The PGT120 has been designed, built and tested using state-of-the-art
engineering and has left the factory in a technically and operationally safe
condition. If used improperly, the units may nevertheless be hazardous to
personnel and may cause injury or damage.
Read the operating instructions carefully and observe the safety notices.
The manufacturers will not assume any liability and warranty if the unit is
used improperly.
2.1 Proper use
The PGT120 must only be used to test the leakage resistance.
Permissible are measurements of:
• leakage resistance from hand to soles,
• leakage resistance from hand to leakage bracelet,
• leakage resistance from shoe to shoe.
Other uses are not permitted.
Modifications or changes made to the PGT120 are not permitted.
Use only original Eltex spare parts and accessories.
2.2 Identification of risks and hazards
Possible risks and hazards resulting from the use of the PGT120 are
referred to in these operating instructions by the following symbols:
Warning!
This symbol appearing in the operating instructions refers to operations
which, if carried out improperly, may result in serious personal injury.
Caution!
This symbol appearing in the operating instructions refers to operations
which, if carried out improperly, may result in damage to property.
To Next Page
Loading...