Product Description
Page 26 of 62 User Manual QT50 Doc ID 1321 version 2.0 Sept. 2018
with CANopen for the QT50 actuator. When this cable is used, only two cable
glands are required, see Chapter 8 Ordering Information and Recommended
Spare Parts.
Figure 10: Hybrid Marine Cable
Further description of the Hybrid Marine Cable is found in the Hybrid Marine
Cable datasheet, Eltorque document ID 1982. The datasheet is available on
www.eltorque.no – Products – System components.
Installation with traditional cabling
With traditional cabling, four glands are required to accommodate both power
and signal cables. When ordering please inform if you intend to use the hybrid
marine cable or a standard cable.
Orientation
The actuator can freely be mounted both vertically standing or horizontally lying
to the side. An upside-down hanging position is also possible.
To Next Page
Loading...
Need help?
General
