Mounting and Installation Instructions
User Manual QT50 Doc ID 1321 version 2.0 Sept. 2018
Page 33 of 62
Cable connection overview
Ensure that electricians have certifications according to applicable laws
and regulations before being allowed to do any work on installations.
The supply voltage must be 1-phase, 110 – 230V AC, 50/60 Hz,
Max 140 VA.
Make sure the fuses are disconnected before you open the actuator.
Caution! When using stranded wires, make sure that all wire strands are properly
fastened in the spring connector. Using ferrules is not recommended.
If ferrules are used the sole responsibility for a correct installation lies on
the installing party.
To Next Page
Loading...
