EasyManua.ls Logo

Elvie Stride - Automatic Functions; Ending Your Session

Elvie Stride
288 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
5.6 Automatic functions
The Hub will automatically switch from Stimulation mode to Expression mode
after two minutes
When the Hub is pumping, it will automatically pause after 40 minutes. It is
recommended that you leave Elvie Stride for 60 minutes before using it again
When the Hub is paused, it will automatically turn o if a button has not been
pressed for five minutes
The Hub will automatically turn o if the battery is empty
The Hub will automatically turn o if a technical error occurs
5.7 Ending your session
1. While leaning forward, press Play/Pause to stop pumping. Turn o the pump by
pressing and holding Power
2. Unclip your bra and use your finger to break the seal around your nipple to avoid
nipple damage
3. Remove the entire Cup from your bra
4. Remove the Cap from the Cup
5. The Cup can be laid flat on a dry surface with the Nipple Tunnel facing up before
decanting if required
6. Unplug and rotate the Stopper to decant your milk
7. Pour milk out as shown below, through the side of the Pour Hole
8. Refer to the Cleaning section of this booklet for cleaning and sanitizing instructions
Tip: Leaning forward when you pause
or stop your session helps the milk drain
from the Nipple Tunnel into the Cup.

Table of Contents

Related product manuals