9
Please keep a copy of these instructions for future reference.
4. Getting ready
This guide will show you how to assemble your pump and how to customize
it to fit your body.
4.1 Charging
The Hub will not turn on while it is charging. It takes approximately two hours to
fully charge the Hub, although this can vary depending on your charging set up.
A full charge lasts approximately five 30 minute sessions. Only use the Charging
Cable provided in the box.
Charge immediately after finishing your pumping session if low battery is indicated.
Tip: Press the Mode button when the Hub is o; the Intensity Lights will show how
much battery is left.
Tip: Close the Charging Port before use to ensure the Hub is as discreet as possible.
Finger Grip
4.2 Taking Elvie Stride apart
1. Remove the Cap. The Hub, Tubes and Cap must be kept away from water
2. Using the Finger Grips, pull the Cup Front away from the Breast Shield
3. Pull the Valve out of the Breast Shield. Then remove the Diaphragm
To Next Page
Loading...
