Tinyhawk III Plus
6.Tinyhawk III Plus
Plus Before starting your flight, make sure to learn flight control and then power
on for flight. Always exercise caution while flying and operate in open and
controlled areas.
Begin by powering on the E8 Transmitter (ELRS-2.4G) and the Transporter II
HD (or Transporter II). The Tinyhawk III Plus is already bound to the E8
Transmitter (ELRS-2.4G) and matched to the correct video channel on your
Transporter II HD (or Transporter II). Power on the Tinyhawk III Plus by sliding
the battery into the battery tray and connecting the power. Once the battery is
inserted, place the Tinyhawk III Plus on a level and stable surface for calibration.
Calibration takes a few seconds, and then the Tinyhawk III Plus is ready to
fly. With a fully charged battery, the Tinyhawk III Plus can fly for around 4
minutes. When the battery voltage reaches 3.2V, it's recommended to land the
Tinyhawk III Plus promptly; flying further could seriously damage your battery,
and EMAX does not advise such operation.
Regenerate
6.1 UNLOCK
To Next Page
Loading...
Need help?
General
