Embraco Scroll SE6015GS-O - Maintenance (Compressor Removal and Replacement)

53
COMPRESSOR MODEL
Sound Power
(dBA)
Sound Power
with Noise jacket
(dBA)
Maximum
Running
Sound
(dBA)
MBP LBP 50Hz 60Hz 50Hz 60Hz
SE6015-SE6021 SE2006-SE2010 71 73 68 70 75
SE6026-SE6036 SE2012-SE2017 73 75 70 72 77
SE6043 SE2020 74 76 71 73 78
SE6053-SE6056 SE2023 75 77 69 71 76
SE6067-SE6078 SE2028-2031 76 78 70 72 77
SE6085-SE6089 SE2039 77 79 71 73 78
Table 11.9 Compressor sound level
Note: Tested in Rated condition of EN12900
11.10 SOUND GENERATION IN REFRIGERATION SYSTEM
Noise and vibrations coming from system or service may come from these sources:
• sound radiation – extend by air
• mechanical vibrations – extended along the parts of the unit and
structure
• gas pulsation – distributed by cooling medium (refrigerant)
The replacement of a compressor is an onerous task and requires an accurate diagnosis of the system
before deciding to proceed with it.
Improper procedures to remove the failed compressor and install a new one, may
cause injury to person, release of refrigerants and oil to the environment, fire and
damages to propriety.
When repairing a refrigeration system, replacing a compressor and installing a new
ones, follow all applicable international regulation and standards (like EN 378-4 or
similar), and the local ones, as well as the safety warnings and recommendations
indicated in these installation instructions.
The compressor replacement must be carried out in properly ventilated ambient.
Disconnect the system from the electrical power.
WARNING
WARNING
WARNING
12. MAINTENANCE (COMPRESSOR REMOVAL AND REPLACEMENT)