EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
19
Installing a 2U storage processor enclosure (SPE) in a cabinet
3. Secure the front of the enclosure to the front vertical channels of
the cabinet using four M5 12.7 mm
screws (two per side), as
shown in Figure 13.
Note: The front screws also help to secure the latch bracket mounted on
the front of the enclosure.
If you are installing the enclosure in a NEBS-compliant environment,
secure the unit to the front channels with the four shape thread rolling
screws supplied with your installation hardware in part number
100-560-644.
Figure 13 Securing the enclosure to the channels
4. Press the front bezel onto the latch brackets at the front of the
cabinet until it snaps into place, then lock the bezel with the key.
See Figure 13.
5. If you are installing another device in the cabinet, continue with
the appropriate instructions. For example, to add a disk array
enclosure above the SPE you just installed, refer to “Installing a
3U disk enclosure (DAE) in a cabinet” on page 50.
CL4138
To Next Page
Loading...
