EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
25
Installing a 2U SPS tray (100-561-369) and SPS units in a cabinet
Figure 19 Securing the 2U SPS tray in the cabinet
4. Install the four M5 x 10mm securing screws (two on each side)
that hold the rear of the 2U SPS tray to the mounting rails, as
shown in Figure 19.
You have installed an SPS tray. Continue to the next section to install
the SPS units.
Rear
Front
EMC3463
Screws (2)
each side
Screws (2)
each side
To Next Page
Loading...
