EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
31
Installing a 2U SPS tray (106-561-015) and SPS units in a cabinet
Removing the filler panels
In most cases, the space into which you will install your enclosure is
covered by a filler panel, which is attached to latch brackets.
Remove any filler panel, then use a flat-blade screwdriver or similar
tool to pry off the latch brackets. Figure 24 shows how to remove a
common filler panel and latch bracket.
Left and right latch brackets Secure 2U bezel
Phillips M5 x 16-mm panhead screws
(black)
Attach the rail mounting hardware
2U mounting tray bezel 1 per tray
26-inch IEC power cord, straight C13 to C14 1 per SPS
(Select per cabinet PDU outlets)
Table 6 SPS mounting materials (Model 106-561-015)
Component Use
(L)
(R)
CL4144
To Next Page
Loading...
