EMC CX4 Series - Installing the Rails in the Cabinet

32
EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
Installing a 2U SPS tray (106-561-015) and SPS units in a cabinet
Figure 24 Removing a filler panel
Installing the rails in the cabinet
This section describes how to mount the rails in the cabinet.
1. After you decide where in the cabinet you want to install the SPS
tray, find the unoccupied 2U section on the rear channels. We
suggest that you install the SPS tray immediately below the SPE, if
possible.
2. From the front of the cabinet, insert the alignment pins on one
mounting rail assembly into the appropriate holes of the selected
2U space on a rear channel. Figure 25 shows the correct channel
holes for the alignment pins.
CL4064