EMC CX4 Series - Page 33

EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
33
Installing a 2U SPS tray (106-561-015) and SPS units in a cabinet
Figure 25 2U pin alignment
3. Extend the rail to the front cabinet channel. Align the holes of the
front rail flange to the inside of the channel, ensure that the rail is
level, and then install an M5 x 16-mm Phillips securing screw in
the center hole, as shown in Figure 26.
Figure 26 Installing the 2U SPS adjustable rails
2U
Alignment pins
here
EMC3479
CL4104
SPS adjustable rail
Right front
Mounting rail
Right rear
Screw (2)
Mounting rail
Alignment
pin (2)