EMC VNX5300 - SP I;O Module Slots

EMC® VNX5300™ Hardware Information Guide
32
EMC® VNX5300™ Hardware Information Guide
SP I/O module slots
There are two SP PCI Gen 2 x4 I/O module slots. These slots support the following
I/O modules (Figure 29):
◆ Two-port 10-Gb/s optical or active Twinax (w/iSCSI protocol)
◆ Four-port 1-Gb/s 10/100/1000 copper iSCSI
◆ Four-port 8-Gb/s optical Fibre Channel (running at 2, 4, or 8-Gb/s)
◆ Two-port 10-Gb/s optical or active Twinax Fibre Channel over Ethernet (FCoE)
Figure 29 Example of SP with a Fibre Channel (FC) I/O module and an iSCSI I/O module
For a full description of the I/O module types used in the SP, go to“I/O modules” on
page 41.
Control Station rear
view
On the rear, viewing from left to right, the Block and File VNX5300 platform Control
Station includes the following hardware components:
◆ AC power in connector
◆ Two PS/2 connectors (keyboard and mouse)—not used
◆ One (DB-9 plug) serial modem connector
◆ One (DB-15) video (VGA socket) connector—not used
◆ Four (RJ-45) NIC (labeled A, CS, B, and MGMT) connectors
5 GND Ground
6 DSR Data set ready
7 RTS Clear to send
8 CTS Request to send
9 RI Ring indicator
Table 20 Serial RS-232/EIA 232 (micro DB-9) connector (socket) pinout (continued)
DB-9 Pin Signal Description
X4
2
3
4
5
6Gb
SAS
8Gb
bre
1
0 X4
6Gb SAS
Cover
Do not remove
Cover
Do not remove
SP I/O Module Slots
VNX-000286