EMC VNX5300 - DME Rear View

System component description
37
EMC® VNX5300™ Hardware Information Guide
Figure 35 Control Station modem (DB-9) plug connector
Table 25 lists the Control Station Ethernet (DB-9) pin signals used on the connector.
DME rear view The rear of the Block and File VNX5300 platform DME does not contain any LEDs
(Figure 36). Only the Data Mover management module and the I/O modules have
LEDs.
Note: Figure 36 is a graphical representation of a Block and File VNX5300 platform DME rear
view with two Data Movers (each Data Mover has one management module, one four-port
8-Gb/s FC I/O module, thee two-port 1-Gb/s plus two-port 1-Gb/s optical I/O modules, and
one filler panel module).
Figure 36 DME (rear view)
CNS-001750
Pin 1
5
6 9
Table 25 Control Station modem (DB-9) plug connector pinout
DB-9 Pin Signal Description
1 CD Carrier detect
2 RXD Received data
3 TXD Transmitted data
4 DTR Data terminal ready
5 GND Ground
6 DSR Data set ready
7 RTS Clear to send
8 CTS Request to send
9 RI Ring indicator
1 DME 4 Four-port 8-Gb/s FC I/O module
2 Filler panel module 5 Data Mover management module
3 Two-port 1-Gb/s copper plus two-port 1-Gb/s
optical I/O module
0
123
0
123
0
1
23
0
12 3
0
12 3
0
1
23
0
12 3
0
12 3
0
12 3
0
1
23
1
235 4
CNS-001767