Quick Start Guide
11
October 2014
Connect to the host system
1. Wire the Gateway’s Ethernet 1 (Primary) or Serial Output connection to the
Host System Network or Serial I/O.
2. For Serial connections, connect A to A, B to B, making sure all terminations are
clean and secured to avoid wiring connection problems.
Figure 5. 1410 Wiring Diagram
A. 5-screw terminal block
+
-AB
24 VDC
(nominal)
Power Input
Serial
Modbus
S
Power
Reset
A
00825-0200-4410_CA.fm Page 11 Thursday, October 16, 2014 6:44 PM
To Next Page
Loading...
