16
f. Without burning the cable, apply heat (250 °F or 120 °C) to
shrink the tubing.
g. Position gland clamping insert so the interior end is flush with the
heat shrink.
h. Fold the cloth shield or braid and drain wires over the clamping
insert and approximately 1/8 inch (3 mm) past the O-ring.
i. Install the gland body into the core processor housing conduit
opening.
6KLHOGHGKHDWVKULQNFRPSOHWHO\FRYHUVH[SRVHGGUDLQZLUHV
To Next Page
Loading...
