1
BEFORE YOU BEGIN
This quick reference guide explains basic installation guidelines for the
Micro Motion
®
ELITE
®
CMF400 sensor. For more information, refer to
the instruction manual that was shipped with the sensor.
European installations
This Micro Motion product complies with all applicable European
directives when properly installed in accordance with the instructions in
this quick reference guide. Refer to the EC declaration of conformity for
directives that apply to this product.
The EC declaration of conformity, with all applicable European
directives, and the complete ATEX Installation Drawings and Instructions
are available on the internet at www.micromotion.com/atex or through
your local Micro Motion support center.
INTRODUCTION
The sensor makes up one part of a Coriolis flowmeter. The other part is a
transmitter.
Installation options
The CMF400 sensor is available with:
• An integral core processor for connecting to a 4-wire remotely
mounted transmitter or to a user-supplied remote host (see Figure 1
or
Figure 2).
• A 9-wire junction box for connecting to a remotely mounted
transmitter, or to a remotely mounted core processor (see Figure 3
or
Figure 4).
©2003, Micro Motion, Inc. All rights reserved. Micro Motion is a registered trademark of Micro Motion, Inc. The Micro
Motion and Emerson logos are trademarks of Emerson Electric Co. All other trademarks are property of their respective
owners.
To Next Page
Loading...
Need help?
General
