Click the General Settings tab to display or edit general transmitter settings.
General Settings tabFigure 2-25:
Click the LCD Mode drop-down to enable or disable the LCD, or to set it to troubleshooting
mode.
Click the Power Source drop-down to select the transmitter power source.
Select the units for measurement variables from the Overall Velocity, PeakVue, and
Temperature drop-down menus.
Click the MHM Access Control drop-down to enable or disable Access Control for AMS
Machinery Manager. Access Control allows AMS Machinery Manager to make changes to
the CSI 9420 configuration.
CAUTION!
If the device will be commissioned in a HART DCS host (e.g., DeltaV or Ovation), do not enable
AMS Machinery Manager to make changes to the configuration.
Click the Write Protect drop-down to specify whether variables can be written to the device.
Configuration
44 MHM-97408, Rev 15
To Next Page
Loading...
Need help?
General
