Figure 3-2: J-Mount transducer disassembly
A. Transducer cable (max. length 15 ft.)
B. Transducer cable nut and chordset
C. Transducer holder
D. Transducer stalk (optional)
E. Transducer
F. Mount
3.2.2
T-Slot transducer removal without extractor tool
This procedure requires venting the line pressure prior to removing the transducer(s).
Before removing and installing transducer(s), connect to the meter using Daniel MeterLink
and collect and save a Maintenance Log.
Note
The following instructions are for transducer removal and installation without the use of
an extractor tool. It is recommended that one work on one transducer assembly at a time
to reduce the possibility of improper assembly with respect to transducer lengths and
location.
• Transducers are always replaced in pairs.
• Update the calibration parameters for every chord when replacing a pair of
transducers. Refer to Modifying the calibration parameters for T-Slot transducers.
Table 3-2: Tools and supplies for disassembly and assembly
Tool list, shop supplies and reference documents
3/8” drive ratchet
3/8” drive extension
3/8” drive 7/16” deep socket
3/8” drive 5/16” hex socket
3/8” drive 1/2” hex socket
3/8” to 1/2” driver adapter
1/2” drive ratchet
1/2” drive 1 ¼” Socket
Maintenance and Troubleshooting manual Meter repairs
3-9000-769 July 2020
Maintenance and Troubleshooting manual 49
To Next Page
Loading...
