Emerson Fisher 4210 - Typical Transmitter Mounting on Type 585 C or 585 CR Actuator

4200 Series Transmitters
Instruction Manual
Form 5596
November 2006
32
37B4775-A / DOC
Figure 17. Typical Transmitter Mounting on Type 585C or 585CR Actuator
Parts for Mounting the Transmitter on
Type 585 or 585C Actuators (figures 16
and 17)
Key Description Part Number
12 Machine Screw, pl steel (2 req’d)
Type 585 & 585R only 1A331928982
21 Mounting Plate, steel
Type 585C and 585CR 24B6336X012
Type 585 and 585R
Size 25, 50 38A0649X012
Size 100 30B7649X012
23 Cap Screw, zn pl steel
Type 585 and 585R (4 req’d) 1C473224052
Type 585C and 585CR (2 req’d) 1A352624052
24 Washer, (2 req’d)
Type 585C and 585CR only 1B865928982
25 Operating Arm, pl steel 19A3811X012
26 Cap Screw, pl steel 1H3284X0012
27 Square Nut, pl steel 16A6711X022
29 Torsional Spring, zn pl steel 19A3812X012
Key Description Part Number
30 Lever Assembly
Size 100 w/ 0.75 thru 2.125 inch travel 16A6705X012
Size 100 w/ 2.5 thru 4 inch travel 16A6706X012
Note
The lever assembly, key 30, is not used with size 25
and 50 actuators. Order the individual parts below
(key 30A through 30C).
30A Lever/Bearing Assembly 18A0645X012
30B Transfer Pin, stainless steel 16A6707X012
30C Pickup Pin, stainless steel 16A6701X012
31 Shoulder Screw, stainless steel 10B5722X012
32 Hex Cap Screw, pl steel (2 req’d) 1C631224052
33 Stem Bracket
Type 585C and 585CR only
Size 25 24B6333X012
Size 50 24B6334X012
36 Sleeve, acetal 16A0428X012
40 Positioner Bracket, zn pl steel
Type 585 and 585R only
Size 25, 50 28A0646X012
Size 100 30B7617X012
83 Lockwasher (2 req’d)
Type 585C and 585CR only 1C225728982