Emerson Liebert GXT4-6000RT230 - Fault List

26 Chapter 7 Operation And Display Panel
7.3.7 Fault List
All UPS fault messages are described in Table 7-5.
Table 7-6 Fault list
No.
Fault
Description
1
UPS self test failed
The battery is bad or weak
2
PFC Out of Order
PFCfailure occurs
3
UPS overload
The UPS is overloaded
4
Inverter Out of Order
The inverter is faulty
5
Battery Weak/Bad
The battery is bad or weak
6
Output Short-circuit
The output connection is short-circuited
7
DC Bus Over-voltage
The DC bus is faulty
8 UPS Over-temperature
Over-temperature occurs to the UPS and the UPS will transfer to
Bypass mode
9
Charger Out of Order
The charger is faulty
10
Fan Out of Order
At least one fan is faulty
11
DC Bus Discharge Fail
DCDC failure occurs
If a fault occurs, the UPS automatically switches to Bypass mode. Only in the case of a battery disconnection fault will
the original operating mode be maintained. The fault message alternates with UPS mode once a second, the red fault
indicator on the operation and display panel lights up and the alarm sounds continuously.
If a fault occurs, proceed as follows:
1. Enter the ALARM CONTROL screen (see Figure 7-18), and select ‘AUDIABLE ALARM ON’ or ‘AUDIBLE ALARM
OFF’ to switch on/off the alarm.
2. Enter the EVENT LOG screen (see Figure 7-21), and select ‘3 CRITICAL’ to view the fault log.
 Note
Please wait patiently when you enter the EVENT LOG screen to view the historical fault log. Because the LCD display panel
needs to read the faults from the DSP at a relatively slow reading speed, the reading time depends on the uploaded information
quantity.
Liebert GXT4 UPS 5000VA ~ 10000VA (230V) User Manual