Emerson Liebert IntelliSlot IS-WEB485ADPT User Manual

Network Settings
15
Web Interface
To access the DNS menu through the Web interface:
• Click on the Configure tab, then Network Settings in the left panel and finally Edit beneath
the table of parameters and descriptions. After making changes, click Save.
5.3 Management Protocol
The Management Protocol Menu allows you to enable or disable
SNMP and configure management protocols. Consult your network
administrator for these settings.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change any parameter:
1. Choose IP Network Settings from the Main Menu, then Management Protocol.
2. Select an option to change, then use the following guide to make changes.
Table 11 Management protocol ranges
Parameter Description & Telnet Menus
SNMP Agent
Enable or disable SNMP for remote management.
SNMP
Communications
Set up access privileges, configure the
Web card to send traps, described in the
next section, SNMP Communications
Menu.
For details on viewing support information,
see 9.2 - Events and Parameters.
Obtain
address
automatically
Specify
address
Options for
how long
card retains
resolved
addresses
Click Edit
to change
settings
Network
Settings
Configure
tab
Management Protocol Menu
-------------------------
1: SNMP Agent enabled
2: SNMP Communications
<ESC>: Cancel menu level
Please select a key ?>
Enable SNMP Agent? [y/n] ?>
SNMP Communications Menu
-------------------------
1: Authentication Traps 'no'
2: RFC-1628 (UPS) MIB 'enabled'
3: - Traps 'enabled'
4: Liebert Global Products MIB 'enabled'
5: - Condition Traps 'enabled'
6: - System Notify Tra p 'enabled'
7: Heartbeat Trap Interval’’
8: Display/Modify Communities
9: Display/Modify Trap Communities
A: Support Information
<ESC>: Cancel menu level
Please select a key ?> 1

Emerson Liebert IntelliSlot IS-WEB485ADPT Specifications

General

Brand	Emerson
Model	Liebert IntelliSlot IS-WEB485ADPT
Category	Network Card
Language	English