Network Settings
24
5.5 Telnet Server
Use the Telnet Server Menu to enable or disable access to the Web
card through a Telnet interface.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change this setting:
1. Choose IP Network Settings from the Main Menu, then Telnet Server.
2. Choose Telnet Server, then specify:
• Enabled to permit Telnet access
• Disabled to block access via Telnet
Web Interface
To access Telnet settings through the Web interface:
• Click on the Configure tab, then Telnet in the left panel and finally Edit in the right panel.
After making changes, click Save.
5.6 Time (SNTP) Menu
This permits setting time options—how often the Web card
synchronizes with the Time Server, which Time Server to use
for synchronization and which the Time Zone the Web card is
operating in.
Telnet Server Menu
-------------------
1: Telnet Server 'enabled'
<ESC>: Cancel menu level
Please select a key ?>
Time Server Menu
-------------------
1: SNTP Time Sync Rate Hourly
2: Time Server time.nist.gov
3: Time Zone (GMT) UTC
<ESC>: Cancel menu level
Please select a key ?>
To Next Page
Loading...
