Factory Settings
34
7.0 FACTORY SETTINGS
Factory default values may be restored for all configuration settings. This step:
• Replaces all user-defined settings described in this manual (see 3.0 - Configuration Overview
through 6.0 - Messaging)
• Restores DHCP service, the factory default, replacing a static IP address or hostname, if config-
ured during installation (see 2.0 - Installation)
7.1 Reset to Factory Defaults
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To restore the factory default settings:
1. Choose Factory Settings from the Main Menu, then choose Reset
to Factory Defaults.
2. Enter y (yes) at the prompt to confirm your choice. To cancel, enter n (no).
3. A message appears until the process is complete.
Web Interface
To restore the factory default settings through the Web interface:
• Click on the Configure tab, then Factory Defaults in the left panel and finally Reset to Fac-
tory Defaults in the right panel.
Reset to factory Defaults? [y/n] ?>
Resetting card to factory defaults...
Factory Settings Menu
----------------------
1: Reset to Factory Defaults
2: Agent Card Information
<ESC>: Cancel menu level
Please select a key ?>
Factory
Defaults
Configure tab
Reset
to Factory
Defaults
To Next Page
Loading...
