Network Settings
27
5.8 Reset Authentication to Factory Defaults
You may reset the Administrator and General User usernames and passwords to the factory defaults.
If you forget your username or password, you may reset them using a serial configuration cable
connection (see Section 2.1.1 or 2.2.1 - Connect the Cable), which provides direct access to the card
without a username or password. To enter a new username and password, see 5.7 - Change
Username / Password.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To reset the usernames and passwords to the factory defaults:
1. Choose IP Network Settings from the Main Menu, then Reset Authentication to Factory
Defaults.
2. Enter y to reset the Administrator and General User usernames and passwords to the default
settings.
Table 17 Factory default passwords
Type of User Factory Default Description
Administrator
Username Liebert
Full access to configuration and control
functions, as well as viewing privileges
Password Liebert
General User
Username User
Viewing privileges only—no access to
configuration or control functions
Password User
Reset authentication to factory Defaults? [y/n] ?>
NOTE
This feature is not available through the Web interface
To Next Page
Loading...
Need help?
General
