26 Chapter 3 Web Page Of RDU-SIC G2
RDU-SIC G2 Card User Manual
3.4.6 System Options
On the RDU-SIC G2 homepage, click the System Options menu in the left part, eight submenus appear, including:
Monitoring Unit, Network Setting, User Management, Date/Time Setting, Restore System, Site Setting, System
Upgrade and System Title.
Monitoring Unit
The Monitoring Unit is used to set the signals of RDU-SIC G2 system, including Sampling, Setting and Alarm
signals, the page is shown in Figure 3-44.
Figure 3-44 Monitoring unit (Sampling)
As for the operation method of the three tabs of Sampling, Setting and Alarm on the Monitoring unit page, refer to
3.4.1 Device Information.
Note
On the Setting tab, if you set ‘Blocked’ for Outgoing Alarm Blocked, when an alarm occurs, it will be blocked, in this case:
1. For current alarms, the page only displays the alarm signals, but not send alarm notifications; after the alarm disappears, it will
not be saved in history alarm;
2. The ‘Blocked’ setting for Outgoing Alarm Blocked will be automatically cleared in 24h.
Network Setting
1. IP Setting
Click the Network Setting under the System Options menu, the page shown in Figure 3-45 pops up.
Figure 3-45 IP setting
On the page shown in Figure 3-45, you can configure the network parameters, such as IP addressing mode, IP, Mask,
GateWay, DNS1 (Preferred DNS server) and DNS2 (Alternate DNS server). After modifying the network parameters,
click the Save button to make the setting effective.
Note
After modifying the IP address, the system will jump to the new IP address by default. You must use the new IP address to
re-login the RDU-SIC G2.
2. Access Management
To Next Page
Loading...
