Emerson Liebert Vertiv RDU-SIC G2 - Page 33

Chapter 3 Web Page Of RDU-SIC G2 31
RDU-SIC G2 Card User Manual
Table 3-1 User security level
Security level
User group
User authority
Level A
Browser
All users can browse equipment information
Level B
Operator
The operators can send control command to intelligent equipment
Level C
Engineer
The engineers can get the following access: Send control command to intelligent
equipment; Browse, control and modify parameters; Download files; Modify user
information of their own
Level D
Administrator
The administrator can get full access: Send control command to intelligent
equipment; Brows, control and modify parameters; Upload and download files;
Modify, add and delete user information; AC teamwork parameter setting;
System upgrade
On the page shown in Figure 3-50, choose the current user, you can perform SMS/Phone Test and Email Test.
Before using the test function, users need to configure the SMS/Email server of current user, refer to Alarm Notification
in 3.4.3 Alarm Management for details.
SMS/Phone Test
Type the phone number in the Phone field, and click the SMS/Phone Test button to test that the telephone number of
current user can be gotten through. If users receive the test SMS and telephone, the test is successful; if not, the test
fails, please check that the telephone number is correct and the SMS Modem is properly connected.
Email Alarm Notify Test
Type the email address in the Email field, and click the Email Test button to test that the email address of current user
is correct. If users receive the test email, the test is successful; if not, the test fails, please check that the information
above is correctly typed.
 Note
When adding and modifying user, you must type the phone number or the email address, or the setting cannot be completed.
Date/Time Setting
Clicking the Date/Time Setting under the System Options menu can synchronize the time. On the page shown in
Figure 3-52, RDU-SIC G2 can get time from the time servers automatically. Type IP address in the Primary Server
textbox and Secondary Server textbox in sequence, type a figure in Interval to calibrate system time textbox, select
the Time zone and Calibrating Protocol, and then click the Set button to make the setting effective.
Figure 3-52 Date/time setting
The RDU-SIC G2 can also get the local time. Choose Specify Date/Time, click the Local Host Time button to get the
local time, and then click the Set button to make the new time effective.
 Note
Time calibration adopts Specify Date/Time by default.
Restore System
Click the Restore System under the System Options menu, the page shown in Figure 3-53 pops up.