PVR-only HART process variables (continued)Table 6-7:
Process variable Primary Varia-
ble (PV)
Secondary
Variable (SV)
Third Variable
(TV)
Fourth Varia-
ble (QV )
Water Total @ Line ✓
TMR-only HART process variablesTable 6-8:
Process variable Primary Varia-
ble (PV)
Secondary
Variable (SV)
Third Variable
(TV)
Fourth Varia-
ble (QV )
Remediated Mass Flow ✓ ✓ ✓
Remediated Mass Total ✓
Remediated Mass Inventory ✓
PVR- and TBR-only HART process variablesTable 6-9:
Process variable Primary Varia-
ble (PV)
Secondary
Variable (SV)
Third Variable
(TV)
Fourth Varia-
ble (QV )
Unremediated Density ✓
PVR, TBR, and TMR HART process variablesTable 6-10:
Process variable Primary Varia-
ble (PV)
Secondary
Variable (SV)
Third Variable
(TV)
Fourth Varia-
ble (QV )
Total Remediated Time ✓
Interaction of HART variables and transmitter outputs
The HART variables are automatically reported through specific transmitter outputs. They
may also be reported through HART burst mode, if enabled on your transmitter.
HART variables and transmitter outputsTable 6-11:
HART variable Reported via Comments
Primary Variable (PV) Primary mA output If one assignment is changed, the other is changed auto-
matically, and vice versa.
Secondary Variable (SV) Not associated with an out-
put
The SV must be configured directly, and the value of the
SV is available only via digital communications.
Tertiary Variable (TV) Frequency Output If one assignment is changed, the other is changed auto-
matically, and vice versa.
Quaternary Variable (QV) Not associated with an out-
put
The QV must be configured directly, and the value of the
QV is available only via digital communications.
Integrate the meter with the control system
84 Micro Motion Model 1500 Transmitters with Analog Outputs
To Next Page
Loading...
