Emerson MICRO MOTION 2700 - 3 Introduction to configuration and commissioning; 3.1 Configuration flowchart

Integratethemeterwiththecontrolsystem
TheHART/Bell202communicationsparametersinclude:
▪HARTAddress(PollingAddress)
▪LoopCurrentMode(ProLinkII)ormAOutputAction(Communicator)
▪BurstParameters(optional)
▪HARTVariables(optional)
Procedure
1.SetProtocoltoHART/Bell202.
Parity,StopBits,andBaudRatearesetautomatically.
2.SetHARTAddresstoavaluebetween0and15.
HARTAddressmustbeuniqueonthenetwork.Thedefaultaddress(0)istypicallyused
unlessyouareinamultidropenvironment.
Tip
DevicesusingHARTprotocoltocommunicatewiththetransmittermayuseeitherHART
AddressorHARTT ag(SoftwareTag)toidentifythetransmitter.Youmaycongureeitheror
both,asrequiredbyyourotherHARTdevices.
3.CheckthesettingofLoopCurrentMode(mAOutputAction)andchangeitifrequired.
Enabled
TheprimarymAoutputreportsprocessdataascongured.
Disabled
TheprimarymAoutputisxedat4mAanddoesnotreportprocessdata.
Tip
WheneveryouuseProLinkIItosetHARTAddressto0,ProLinkIIalsoenablesLoopCurrent
Mode.WheneveryouuseProLinkIItosetHARTAddresstoanyothervalue,ProLinkIIalso
disablesLoopCurrentMode.Thisisdesignedtomakeiteasiertocongurethetransmitter
forlegacybehavior.BesuretoverifyLoopCurrentModeaftersettingHARTAddress.
4.(Optional)EnableandcongureBurstParameters.
Tip
Intypicalinstallations,burstmodeisdisabled.Enableburstmodeonlyifanotherdeviceon
thenetworkrequiresburstmodecommunication.
5.(Optional)CongureHARTVariables.
CongureBurstParameters
DisplayNotavailable
ProLinkII
ProLink→Conguration→Device→BurstSetup
Communicator
5,3,4
DetailedSetup→CongOutputs→HARTOutput
Burstmodeisaspecializedmodeofcommunicationduringwhichthetransmitterregularly
broadcastsHARTdigitalinformationovertheprimarymAoutput.Theburstparameterscontrol
theinformationthatisbroadcastwhenburstmodeisenabled.
CongurationandUseManualSupplement
21