Emerson PACSystems RSTi-EP - Page 26

23 PACSystems™ RSTi-EP EPSCPE115 Standalone CPU Quick Start Guide GFK-3039C
2. Power off the unit and wait for 5 minutes to allow the internal supercapacitors to
discharge completely.
3. Clean the exterior surfaces of the unit before bringing it into a suitably clean lab
environment. Detach the side panel cover by removing the (M3) screws with a
Phillip’s head screwdriver.
Figure 13: Controller Side Panel
Figure 14: Supercapapacitor Board
Location
4. Using a screwdriver, remove the two M2.5 screws and detach the supercapacitor
card (Figure 14) from the carrier board (Figure 15).
5. Disconnect the mating connectors.