Quick Panel Operator User Manual Appendix A
GFK-2847AA Jan 2023
Product Certifications and Installation Guidelines 102
A-5 EMC Installation and Operation
Considerations
This equipment is intended for industrial use only and complies with a
minimum level of EMC performance as defined by EN 61000-6-2 and EN
61000-6-4 standards. To meet these requirements, the following
installation and operation considerations were taken into account:
•
Shielding USB cables
•
Limiting RS-232 cables to 15 m (49.2 ft) in length
•
Using Audio ports only during operational maintenance
Although these considerations were deliberated during testing, actual
EMC environments vary greatly. Therefore, these considerations may not
be necessary. Likewise, additional measures, such as filtering, wire
separation, and cable routing, may need to be considered to ensure the
intended operation of the overall system.
A-6 Government Regulations
The FCC requires the following note to be published according to FCC
guidelines:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Changes or modifications to this unit that are not expressly approved by
Emerson could void the user’s authority to operate the equipment.
Industry Canada requires the following note to be published:
Note: This Class A digital apparatus complies with Canadian CAN ICES 3 (A)/NMB 3(A).
To Next Page
Loading...
Need help?
General
