5
Manual Supplement
00809-0200-4853, Rev AB
Rosemount 3051S Series Pressure Transmitter
November 2017
Rosemount 3051S Series Pressure Transmitter
3.0 Installation
For complete configuration details using Fieldbus, reference the Rosemount 3051S FOUNDATION
Fieldbus Reference Manual.
4.0 Operation and maintenance
For operation and maintenance details using Fieldbus, reference the Rosemount 3051S FOUNDATION
Fieldbus Reference Manual.
5.0 Troubleshooting
For complete troubleshooting details using Fieldbus, reference the Rosemount 3051S FOUNDATION
Fieldbus Reference Manual.
5.1 Overview
This section provides summarized troubleshooting suggestions for the most common operating
problems on the Rosemount
™
3051S Series Pressure Transmitter with FOUNDATION Fieldbus.
If a malfunction is suspected despite the absence of any diagnostic messages on the communicator
display, follow the procedures described to verify transmitter hardware and process connections are in
good working order. Always deal with the most likely and easiest-to-check conditions first.
5.2 Safety messages
Procedures and instructions in this section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol
(). Refer to the following safety messages before performing an operation preceded
by this symbol.
Explosions could result in death or serious injury.
Do not remove the transmitter cover in explosive atmospheres when the circuit is live.
Before connecting an Emerson
™
Field Communicator in an explosive atmosphere, make sure the
instruments in the segment are installed in accordance with intrinsically safe or non-incendive
field wiring practices.
Verify the operating atmosphere of the transmitter is consistent with the appropriate hazardous
locations certifications.
Both transmitter covers must be fully engaged to meet flameproof/explosion-proof
requirements.
To Next Page
Loading...
