Emerson Rosemount 3101 - 5.6.1 Use the integral buttons to change the level at 4 mA; 5.6.2 Use the integral buttons to change the level at 20 mA

5.6.1 Use the integral buttons to change the level at 4mA
Procedure
1. From the PV display, press the green button ↓ repeatedly until 4 is
shown.
2. Press the blue button → to indicate the present value of the 4 mA
level.
• If this value is correct, press the red button ↵ and then the green
button ↓ to get to the next menu.
• Otherwise, continue with step 3.
3. Press the blue button → to start editing. The first digit flashes.
4. Press the green button ↓ repeatedly to edit the flashing digit.
5. Press the blue button → to move to the next digit. That digit flashes.
6. Repeat steps 5 and 6 until the last digit is flashing and edited as
required.
7. Press the blue button → to confirm the new 4 mA level. No flashing
digits.
• Press the red button ↵ to save the new 4 mA level. The next
menu appears.
• Press the blue button → to exit without saving. The 4 menu
appears.
5.6.2 Use the integral buttons to change the level at 20mA
Procedure
1. From the PV display, press the green button ↓ repeatedly until 20 is
shown.
2. Press the blue button → to indicate the present value of the 20 mA
level.
• If this value is correct, press the red button ↵ and then the green
button ↓ to get to the next menu.
• Otherwise, continue with step 3.
3. Press the blue button → to start editing. The first digit flashes.
4. Press the green button ↓ repeatedly to edit the flashing digit.
5. Press the blue button → to move to the next digit. That digit flashes.
6. Repeat steps 5 and 6 until the last digit is flashing and edited as
required.
August 2019 Quick Start Guide
Quick Start Guide 33