Emerson Rosemount 8800D Series - Verify configuration

Quick Installation Guide
00825-0100-4004, Rev DB
December 2011
Rosemount 8800D
21
International IECEx Certifications
Intrinsic Safety
IEC 60079-0 : 2007
IEC 60079-11 : 2006
I7 Certification No. IECEx BAS05.0028X
Ex ia IIC T4 Ga (-60 °C  T
a
 70 °C) 4-20 mA HART
(-60 °C  T
a
 60 °C) Fieldbus
FISCO/FNICO
IG Certification No. IECEx BAS 05.0028X
Ex ia IIC T4 Ga (-60 °C  T
a
 60 °C)
Input Parameters:
U
i
= 17.5 Vdc
I
i
= 380 mA
P
i
= 5.32 W
C
i
= 0 F
L
i
10H
Special conditions for safe use (x)
When fitted with 90V transient suppressors (T1 Option), the equipment is not capable of
passing the 500V isolation test. This must be taken into account upon installation.
The enclosure may be made from aluminium alloy and given a protective polyurethane paint
finish; however, care should be taken to protect it from impact or abrasion when located in
Zone 0 environment. The polyurethane paint finish may constitute an electrostatic hazard
and must only be cleaned with a damp cloth.
When the equipment is installed, particular precautions must be taken to ensure, taking into
account the effect of process fluid temperature, that the ambient temperature of the
electrical housing of the equipment meets the marked protection type temperature range.
4-20 mA HART Entity
Parameters
Fieldbus Entity Parameters
U
i
= 30 VDC U
i
= 30 VDC
I
i
(1)
(1) Total for transmitter
= 185 mA I
i
= 300 mA
P
i
(1)
= 1.0 W P
i
= 1.3 W
C
i
= 0 F C
i
= 0 F
L
i
< 0.97 mH L
i
< 10 H
4004_RevDB.fm Page 21 Wednesday, November 23, 2011 3:06 PM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com