2.3 Attach detector to tilt mount
Figure 2-6: Tilt mount
A. Tilt holding plate
B. Horizontal locking screw
C. Tilt mount
D. Vertical locking screw
E. Detector holding plate
Figure 2-7: Tilt mount with dimensions
Procedure
1. Unpack the detector.
2. The device is provided with two plastic plugs (See image below). The stainless-steel
stop plug used to seal the unused conduit will be included in the device.
Remember, seal the detector with the stainless-steel plug before use. Refrain from
losing the plug in any case
Installation Manual
September2023 00809-1400-4975
14 Emerson.com
To Next Page
Loading...
