Emerson Rosemount 975 - Install Protective Cover

NOTICE
To comply with EMC directive 2014/30/EU and protect against interference caused
by radio frequency interference (RFI) and electromagnetic interference (EMI), shield
the cable to the detector and ground the detector.
2.6 Install the protective cover
NOTICE
Always install the protective cover with the detector.
The protective cover is available in ABS plastic or stainless steel.
Table 2-3: Protective cover
Material Part number
ABS plastic PN 877263
Stainless steel PN 877163
Procedure
1. Place the protective cover on top of the detector.
2. Secure the protective cover by tightening the screw.
Note
When installing the stainless steel protective cover, the same installation
instructions apply.
2.7
Aim the detector
Aim the detector toward the center of the detection zone and make sure you have a
completely unobstructed view of the protected area.
Installation Manual
September2023 00809-1400-4975
22 Emerson.com