A. Detector with two plastic plugs
B. Product packaging with stainless-steel plug attachment
3. Insert location pins on the tilt mount into the openings on detector housing.
4. Thread the holding screw and tighten it.
Note
To change the detector field of view, release the horizontal and vertical locking
screws.
5. Point the detector toward the protected area and ensure the view of the area is
unobstructed.
6. Secure the detector in that position by tightening the locking screws on the tilt
mount.
The detector is now correctly located, aligned, and ready to be connected to the
system.
2.4
Open the back cover
Procedure
1. Loosen the back cover security screw.
Manual Installation
00809-1400-4975 September2023
Rosemount 975 15
To Next Page
Loading...
