Emerson Rosemount SAM42 - Page 60

5.1.4 Sand rate alarm deadband
When the sand rate drops below the Sand Alarm Level minus the
Alarm Bound Limit, sand mass accumulation is halted. Enter an
appropriate Limit.
Default value: 0.100 g/s
5.1.5 Applying alarms
Press Apply in the bottom right-hand corner of the window. Then,
press OK to exit to the home screen.
Alarm values are also visible on the commissioning application home
screen.
Quick Start Guide May2024
60 Emerson.com/Rosemount