Emerson Tescom ER5000 Series - Page 165

ER5000 —
165
The ERTune™ Program: Basic Features
The Commands in the Profile Builder
IMPORTANT
!
IMPORTANT
!
The unit of measurement for the setpoint value parameter
in these commands matches the unit of measurement for feedback set
during Step 7 of the Setup Process or when you followed the steps To
change the range of feedback values tracked by the ERTune™ program.
Step
Initiates a step setpoint change to the value entered in the Setpoint
to Step to entry eld.
Ramp
Initiates a ramp setpoint change to the value entered in the Setpoint
to Ramp to entry eld. The duration, in seconds, of the ramp-up or
ramp-down is set in the Time to Ramp (sec) entry eld.
Dwell
Maintains the current setpoint for the amount of time, in seconds,
entered in the Time to Dwell (sec) entry eld.
Loop
Allows the Prole to loop multiple times through a sequence of
command segments, beginning with the segment entered in the
Loop to Segment entry eld.
NOTENOTE
CAUTIONCAUTION
WARNINGWARNING
The command sequence will run the number of times entered in
the Number of Loops entry eld. A value of 0 in the Number of Loops entry
eld will cause the loop to run perpetually.