38 SI-Ethernet User Guide
Issue: 1
6 Parameters
The Ethernet interface holds two parameter databases; the Ethernet interface internal
parameter database and the host drive's parameter database.
The Ethernet interface internal parameters can be accessed from the drive's keypad, a
user program in a MCi200/MCi210 option module, PC Tools applications software or a
module in another slot of the drive. The notation S.mm.ppp is used to access these
parameters where S is the slot number, mm is the menu number and ppp is the
parameter number. For example, to access Pr 03.010 of a MCi210 installed in slot 2 of a
drive from a module in slot 3, it will be accessed using Pr 2.03.010.
The Ethernet interface will also hold a copy of the host drive's database. At power up, if
the stored drive database is different to that of the drive, the Ethernet interface will
upload the drive's database and overwrite the stored database. If the two databases
match, the drive's database will not be uploaded.
A module that is powered up for the first time will not contain a drive database and
therefore will perform a drive database upload.
6.1 Menus
Table 6.1 Ethernet internal menus
S is the slot number where the module is installed.
Menu 0 within the Ethernet interface, is also displayed in the drive menu 15, 16, 17 or
24 depending on which slot the Ethernet interface is installed to and the setting of
Option Slot Identifiers (11.056).
By default, the SI-Ethernet option module will be either menu 15, 16 or 17 and the
onboard Ethernet interface will be menu 24.
Menu Description
S.0 Ethernet setup (MM.ppp)
S.2 Ethernet configuration
S.9 Resources
S.10 Easy mode cyclic data
S.11 Synchronization
S.15 Modbus
S.20 EtherNet/IP setup
S.21 EtherNet/IP in mappings
S.22 EtherNet/IP out mappings
S.23 EtherNet/IP fault values
To Next Page
Loading...
