Table 5-3: System Settings → Protocols → Ethernet/IP (continued)
Terms Description
NaN Not a number is reported if the value’s associated status indicates a
critical failure.
+Inf Positive infinity is reported if the value’s associated status indicates a
critical failure.
-Inf Negative infinity is reported if the value’s associated status indicates a
critical failure.
Other User defined value is reported if the value’s associated status indicates
a critical failure.
Value reported for error
(native integer)
User defined value is reported if the value’s associated status indicates
a critical failure. Only used if the Gateway is using integer
representation.
Unmapped parameter
read response
This is the value returned by the Gateway if the EtherNet/IP master
requests a register with no data assigned to it (empty register). It is
recommended this be set to zero fill to prevent errors.
Parameter mapping Register Mapping is the process of assigning data points from wireless
field devices to EtherNet/IP registers. These registers can then be read
by a EtherNet/IP master or client. EtherNet/IP register mapping can be
found by navigating to System Settings → Protocols → Ethernet/IP.
Operation and Maintenance Reference Manual
September 2020 00809-0200-4410
42 Emerson.com/Rosemount
To Next Page
Loading...
Need help?
General
