Emerson XWEB300D - User Manual

XWEB300D/500D/500 EVO (V.1.2)
INSTALLATION MANUAL

Summary

1. PRODUCT DISPOSAL (WEEE)

2. THE RECIPIENTS OF THIS MANUAL

3. PACKAGE

4. XWEB INSTALLATION

5. CONTROLLER INSTALLATION PROCEDURE

5.1 CONTROLLER CONFIGURATION

Explains programming controllers with serial addresses using 'Adr' parameter and fitting terminating resistors.

5.1.1 CONFIGURATION FOR XC400;600;800;900 AND XH200;300;400 SERIES

Instructions for configuring instruments with two serial addresses, referencing their specific manuals.

5.1.2 CONFIGURATION FOR XJA;XJP;XJM MODELS

Guidance on configuring XJA/XJP/XJM series instruments with one or more Modbus addresses.

5.1.3 CONFIGURATION FOR XEV SERIES

Steps to configure XEV series drivers for electronic valves in combination with a main controller.

5.1.4 ENERGY METERS AND THIRD PARTY INSTRUMENT CONFIGURATION

Procedure for configuring non-Dixell instruments, including baudrate and serial settings.

6. REMOTE CONNECTIVITY

6.1 CONNECTIVITY WITH CROSS CABLE

Instructions for local PC access using a cross network cable and setting up the IP address.

6.2 MODEM CONNECTIVITY (“OR POINT-TO-POINT CONNECTION)

Explains establishing a connection between PC and XWEB-EVO using a phone line and modem.

6.2.1 SETTING UP THE REMOTE ACCESS CONNECTION

Step-by-step guide for configuring a remote access connection on a PC using Windows 7.

6.2.2 MAKING THE REMOTE ACCESS CALL

Details on how to initiate the remote access call to XWEB-EVO after setup, using Windows 7.

7. OPERATION

8. SYSTEM DATA

9. TRADEMARKS

10. NOTES

Emerson XWEB300D Specifications

General

Model/Series	XWEB300D
Type	Controller
Input Voltage	24 VDC
Communication Protocol	Modbus, BACnet, LonWorks
Number of Inputs	Up to 16
Number of Outputs	Up to 8
Connectivity	Ethernet, RS-485
Display	LCD
Storage Temperature	-20 to 70 °C
Memory	Flash memory