1592028010 XWEB300D_500D_500 EVO STP GB r1.2 12.06.2017.doc XWEB3000/5000 EVO 17/22
6.2 MODEM CONNECTIVITY (“OR POINT-TO-POINT CONNECTION”)
A modem connection makes it possible to set up a connection between PC and XWEB-EVO through the
phone line. This type of connection is usually required when there is no internet connection available on the
local LAN line. An analogue phone line is required (not ISDN), which we recommend setting up exclusively
for XWEB-EVO use.
Caution: only use the supplied modem or a Dixell-recommended one. The supported external modems are:
230/100 or 24V XWEBMODEM.
Do not buy any type of modem other than the listed ones. Dixell cannot be held responsible for any damage
caused by the use of non-recommended modems. Connect the modem to the serial port on the back of the
unit, using the cable supplied with the modem. Connect the modem to the telephone line using the cable
supplied by the manufacturer. Be careful of any telephone switchboard to access the external line.
The connection procedure is divided into two parts:
6.2.1 SETTING UP THE REMOTE ACCESS CONNECTION
The configuration of your PC includes the creation of a "remote access" connection. The illustrations below
mark the steps that need to be carried out to complete the procedure to set up a remote access connection
with WINDOWS 7.
To Next Page
Loading...
Need help?
General
