emesent HOVERMAP - Initial DJI Settings; DJI Onboard SDK Activation

DJI M300/M350 preparation for Hovermap operation
Release date: 30 Apr 2024
Revision: 2.2
12
7.
8.
9.
10.
11.
1.
2.
3.
a.
i.
ii.
b.
4.
1.
2.
3.
4.
5.
All other parameters are set by Hovermap when it is turned on.
In DJI Assistant 2, click Back.
Reboot the drone.
Restart DJI Assistant 2.
Check that the SDK settings have been saved correctly.
3.1.3 Initial DJI settings
On the tablet connected to the controller, launch DJI Pilot.
Allow any updates during start-up.
In the three-dot menu at the top-right of the screen, set the following:
On the Main Controller Settings tab:
Multiple flight modes: On
Set Max Height: 119 m
On the Aircraft Battery tab, disable Smart Return to Home.
Close DJI Pilot.
3.1.4 DJI Onboard SDK activation
SDK activation only needs to be done once per drone. Register and activate the onboard SDK
application as follows:
Power on the controller.
Power on the drone.
With DJI Assistant 2 running, connect the M210 or M300 drone to the USB port of the computer.
In DJI Assistant 2, click Onboard SDK. Ensure that all fields are ticked (as above).
Connect the computer to the internet.
Note
This activation process is only required for the M210 and M300. Onboard SDK
activation is not needed for the M350.
