emesent HOVERMAP - DJI Mobile SDK Activation; Sanity Check for Hovermap Communications

DJI M300/M350 preparation for Hovermap operation
Release date: 30 Apr 2024
Revision: 2.2
13
6.
7.
a.
b.
c.
8.
9.
10.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
Double-check the SDK settings.
With Hovermap correctly mounted and connected to the drone (via the Emesent-supplied cable):
Open the DJI Pilot app on the controller.
Note: Make sure that the controller is connected to a Wi-Fi network with access to the
Internet to proceed with the SDK activation.
Press the power button on the Hovermap.
Start a scan and let it run for 2 minutes.
Stop the scan and power off the drone and the controller.
Disconnect the USB cable between the drone and the computer.
Power on the drone and controller again.
3.1.5 DJI Mobile SDK activation
SDK activation only needs to be done once per mobile device. Perform the activation as follows:
Power on the device.
Install Emesent Commander.
Connect the device to the internet.
Launch Emesent Commander.
Allow permission requests when prompted.
Enter the user information then select the Allow registration with DJI to use drones option.
Connect to Hovermap Wi-Fi.
3.2 Sanity check for Hovermap communications
Perform a quick sanity check to ensure that the drone, Hovermap, and controllers are configured
correctly and that communications between the drone and the Hovermap have been established.
Mount Hovermap to the drone and connect the power and the serial cables.
For Hovermap autonomy operations, connect the Samsung Galaxy tablet to the controller.
Power up the controller.
Power up the drone first, and then power on Hovermap.
When prompted, open the Emesent Commander app, or touch once and select Only once.