DiSEqC: 0=off, 1=LNB1, 2=LNB2, 3=LNB3, 4=LNB4 If a DiSEqC command is
required for tuning, this can be added to the satlist file instead of manual selection.
Also stored in the file is a version number for reference which is displayed on Info
display.
A typical file starts like:
"VERSION";2;"Europe 7-12-2010";;;;;;;
"DVB";"Intelsat45E";11680;0;05787;2;0;1;1;"E";450;0
"DVB";"Turksat 42E";11729;0;15553;3;0;50600;126;"E";420;0
"DVB";"Hellas 39E";12524;0;30000;5;0;13;28;"E";390;0
"DVB";"Eutelsat36E";11727;0;27500;2;0;10100;878;"E";360;0
When entering a frequency to identify a satellite, if the ONID and TSID are not known,
enter 0 and instead of “Wrong Satellite”, the actual ONID and TSID are displayed.
For DirecTV transponders using DSS instead of DVB, no MPEG data is read and
identification is confirmed by locking on the Satellite list frequency. These frequencies
should be are chosen so that locking on other satellites is not likely.
To Next Page
Loading...
