EMKO EAOM-3-STP-ALT User Manual

Connection Schematic (Without Remote Start P16 = 0 (dis))
Connection Schematic (With Remote Signal P16 = 1)
c
1- Connect the unit as shown in the appropriate diagram above. Be sure to connect the battery supply the right way round and
battery negative should be grounded.
2- Use Alternator connection only generator application (P00 = Gen)
The fuses should be as follows:
FUSE-1
FUSE-2
According to current required by solenoids (Max. 16A. T)
Max. 1A. T
5
ALTERNATOR
FUSE-2
L1
N
12
CHARGE
GEN.
D+(W.L.)
B+
FUSE-1
40 A
40 A
BATTERY
+
-BAT
STARTER
BATTERY NEGATIVE MUST BE GROUNDED
START
RELAY
SOLENOID
RELAY
CONF. INPUT-1 HIGH TEMPERATURE LOW OIL PRESSURE
HORN
9 5
6
10
1
2
4
7
13
CONF.OUT
c
1
8
CONF. INPUT-2
11
PREHEAT
+BAT
10A@28VDC
10A@28VDC
10A@28VDC
c
OR ALARM
3
+BAT
CHA
RGE
G
ENERA
T
OR
2
c
1- Connect the unit as shown in the appropriate diagram above. Be sure to connect the battery supply the right way round and
battery negative should be grounded.
2- Use Alternator connection only generator application (P00 = Gen)
The fuses should be as follows:
FUSE-1
FUSE-2
According to current required by solenoids (Max. 16A. T)
Max. 1A. T
ALTERNATOR
FUSE-2
L1
N
12
CHARGE
GEN.
D+(W.L.)
B+
FUSE-1
40 A
40 A
BATTERY
+
-BAT
STARTER
BATTERY NEGATIVE MUST BE GROUNDED
START
RELAY
SOLENOID
RELAY
CONF. INPUT-1 HIGH TEMPERATURE LOW OIL PRESSURE
HORN
9 5
6
10
1
2
4
7
13
CONF.OUT
c
1
8
REMOTE START SIGNAL
11
PREHEAT
+BAT
10A@28VDC
10A@28VDC
10A@28VDC
c
OR ALARM
3
+BAT
CHA
RGE
G
ENERA
T
OR
2
Manual and Remote Start Unit with Key Switch, 72x72 DIN Size

EMKO EAOM-3-STP-ALT Specifications

General

Brand	EMKO
Model	EAOM-3-STP-ALT
Category	Controller
Language	English