ENEN
35
7. USER VISUALIZATION AND SET-UP
7.2.2 Screen 4.3 - Compressor limitations
On screen 4.3 you can set compressor limitations to:
• Limit the noise of the HP at certain times, for example at night
• Limit the electrical absorption of the HP, to avoid exceeding the
withdrawal threshold from the mains.
Press on the cell to change the value
Daily limitation:
Start time and
max step
of compressor
Maximum withdrawal threshold
from the mains
Graphic
representation
of the daily
limitation
7.2.3 Screen 4.4 – Heating water temperature
On screen 4.4 you can set
target temperature of the water being heated:
Press on the cell to change its value
Daily programming
of the screed: (Set 1)
Start time
and temperature
of Target
Temperature
of Target for fan-coils (Set 2)
Graphic representa-
tion of the
daily
programming
of screed
7.2 Heat Pump User Screens
On screen 4.1 HEAT PUMP the icon is now visible,
as additional screens are available.
7.2.1 Screen 4.2 - Input/Output Status
The following information is available on this screen:
Input status
Output status
USER
To Next Page
Loading...
Need help?
General